Direkt zum Inhalt | Direkt zur Navigation
Nalazite se ovde:

April 2022

Sensor protects against total failure

Dewatering pumps

If water penetrates the housing of a dewatering pump unnoticed, expensive damage may follow - unless Tsurumi's new leakage sensor is installed. Retrofitting is easy and recommended, especially since many tenders require pumps to be equipped accordingly.

The manufacturer had to use a trick for this, because such a retrofit is not technically provided for: the pumps are designed so robustly that they run safely and reliably in normal operation. However, it can never be ruled out that the abrasive force of the water flow will overcome all the built-in barriers.

Critical points for probably all manufacturers are the cable entry and the mechanical seal at the bottom of the housing. Tsurumi's protective measures at these points: Each electrical conductor is encapsulated in synthetic resin to exclude creeping moisture. And the double internal seal of the oil chamber is made of silicon carbide, almost as hard as diamond.

Clever: the manufacturer has integrated the sensor into the screw of the oil drain. Installation is literally done in no time: old screw out, new in.

To detect water ingress into the housing via the oil chamber, the sensor measures the electrical conductivity of the lubricating oil. Pure oil conducts almost no current. So if the electrical resistance is consistently low, water must have entered. Then the pump should be switched off immediately to prevent lubrication damage or water being drawn into the engine compartment. Also, the risk of electric hazard to the user should never be underestimated. Replacing the seal solves the problem and makes the pump ready again. Thanks to Tsurumi's modular design, the work can be done by the user himself.

The sensor cable goes to the control cabinet, where Tsurumi's "smart" Connect Box may also be installed. This switches the pump off and informs the user, for example, via a message on the mobile phone network. At the same time, other operating parameters can be called up and monitored. Alternatively, a relay is sufficient to turn off the pump when the sensor activates. The retrofit part is called TSS-TEG and should help significantly to save the pump and the dewatering project from a major failure.

Many tenders call for pumps with leakage sensors to reduce the risk of failure of the dewatering system (Photo: Tsurumi)
Za dodatne informacije kontaktirajte:
Mr. Birger Schmidt, Marketing
Tsurumi (Europe) GmbH
Wahlerstr. 10
40472 Düsseldorf
Nemačka
Tel.: +49 211 417 9373
Faks: +49 211 479 1429
E-pošta: sales@tsurumi.eu

Kompanija Tsurumi je jedan od najiskusnijih proizvođača pumpi na svetu. U svom modernom pogonu u Kjotu kompanija Tsurumi proizvodi više potapajućih pumpi godišnje od bilo kog drugog proizvođača pumpi. U asortimanu kompanije Tsurumi trenutno postoji preko 1800 različitih modela pumpi u koje spadaju poluvrtložne, vrtložne, nezačepljujuće, rezne, komunalne i odvodnjavajuće pumpe, uređaji za kanalizaciju i otpadne vode, aeratori i ventilatori, uređaji za dekantovanje i skidači pene. Kompanija Tsurumi je prisutna širom sveta zahvaljujući svojoj velikoj distributerskoj mreži u Evropi, Severnoj i Južnoj Americi, Aziji, Australiji i delovima Afrike.
www.tsurumi.eu