Direkt zum Inhalt | Direkt zur Navigation
You are here:

Well pump at Eternit AG, Germany

The project:

Reconstruction of a well, installation and adaptation of a new pump


Eternit AG

Performing company:

Haugrund und Runte Elektromaschinenbau GmbH

Project lead at Tsurumi:

Mr. Jürgen Rohring (Regional Sales Lead Construction NRW)

The problem:

Rebuilding of a well system.

Measure: Replacement of three small pumps of "lumberyard quality".

The use of a higher-quality product should permit longer service life and adjustment of each water fountain.

The solution:

Replacement of the three pumps with a Tsurumi model 50UT2.75S (750W, 230V) submersible pump.

This is a portable, rugged pump in a cast iron variant with a vortex impeller.

The pump was modified in such a way that three fountain nozzles can be operated with the option of controlling each water fountain individually or all together.

In the event of abrasive and corrosive utilization, stronger wear and tear will take place naturally in certain components. With regards to the above application wear and tear can take place mainly in impeller, agitator, suction plate, shaft sleeve, oil ring, mechanical seal, pump casing, strainer, motor casing and discharge coupling. Depending on the working conditions the lifetime of those parts might vary significantly and can be shorter than the legal warranty period.
In this regard, please pay attention to our general terms and conditions that we also send to you by mail on request.