Direkt zum Inhalt | Direkt zur Navigation
Jūs esate čia:

April 2021

Quick check of the oil chamber

Maintenance tools for dewatering pumps

For dewatering and wastewater pumps to last a long time, every part of them must run nicely. If users suspect a defect in the oil chamber: Tsurumi has developed a test tool that provides information about the tightness of the pump.

The tool is still only in use at Tsurumi´s service facilities. For example, when rental pumps are returned and checked to the maximum. However, the manufacturer is considering offering it on the market if there is sufficient customer interest. Those who maintain a well-stocked workshop can also produce it themselves.

The tool is screwed into the thread of the oil drain and pressurized with compressed air. Two bar are sufficient to check the tightness of the oil chamber. If the needle of the manometer drops, a leak is to be suspected.

Sometimes a critical look at the oil is enough: If water or dirt is visible in it, this indicates a leak. The mechanical seal on the shaft is often involved. It shields the water-bearing components from the rest of the unit. Enormous forces are at work here. Tsurumi therefore manufactures the component from silicon carbide, the second hardest material after diamond. To further increase safety, the seal is designed with a double inner layer. The manufacturer also takes a special approach to the lubrication system. Thanks to its centrifugal oil distributor, an in-house development, it achieves permanent lubrication of all relevant areas - regardless of whether the pump is lying down or standing still.

A regular check of the pump is always advisable. The costs of a capital damage due to water penetration are likely to exceed any maintenance effort by far. When it comes to the electrical system, Tsurumi customers can lean back and relax completely: Thanks to individually isolated conductors, even wicking water damage is virtually eliminated.

Dėl papildomos informacijos kreipkitės į:
rinkodaros vadovą Birger Schmidt
"Tsurumi (Europe) GmbH"
Wahlerstr. 10
40472 Düsseldorf
Germany (Vokietija)
Tel.: +49 211 417 9373
Faks.: +49 211 479 1429
El. pašto adresas: sales@tsurumi.eu

"Tsurumi" – viena labiausiai patyrusių siurblių gamintojų pasaulyje. Modernioje Kioto gamykloje "Tsurumi" per metus pagamina daugiau panardinamųjų siurblių nei bet kuris siurblių gamintojas pasaulyje. Šiuo metu "Tsurumi" asortimente – daugiau nei 1 800 skirtingų siurblių modelių, įskaitant pusiau sukūrinius, sukūrinius, neužsikemšančius, su peiliais, statybinius ir vandens šalinimo, kanalizacijos ir vandens nuotekų siurblius, aeratorius ir pūstuvus, dekantavimo įrenginius ir putų nugriebtuvus. "Tsurumi" veikia visame pasaulyje. Europoje, Šiaurės ir Pietų Amerikoje, Azijoje, Australijoje ir tam tikrose Afrikose dalyse suformuotas platus įgaliotasis atstovų tinklas.
www.tsurumi.eu